Viser søkeresultater for "

Minianlegg

"
Shure MX418/S Kondensator Schwanenhals-Mikrofon
Shure MX418/S Kondensator Schwanenhals-Mikrofon

Shure MX418/S, Gooseneck Condenser Microphone@+The Microflex Miniature gooseneck microphones are condenser microphones that offer a high degree of flexibility through freely adjustable gooseneck and interchangeable condenser capsules with different directional characteristics. Designed for easy replacement and available in cardioid (C), super-cardioid (S) and omnidirectional (O) polar patterns, the interchangeable cartridges offer wide frequency response and accurate sound reproduction for a wide variety of applications, such as houses of worship, courtrooms and conference centres. Plus, the condenser cartridges fit every model in the Microflex product line for enhanced convenience and consistent sound.@+@+@+Microflex Gooseneck microphones are available in four different models, lengths and mounting options. In addition, each Microflex gooseneck microphone is fitted with a balanced, transformer-less output for increased immunity to electromagnetic hum and RF interference over long cable runs.@+@+, Characteristics: Super-cardioid, With very slender gooseneck (45cm long), Integrated amplifier, Changeable Mini Capsule (modular), Incl. accessories: Windscreen, mounting and vibration absorbers, Frequency range: 50 Hz - 17 kHz, Output impedance: 180 Ohm, Open circuit sensitivity: Super-cardioid: -33.5 dBV / Pa (21.1 mV), Maximum SPL (1 kHz at 1% THD, 1 kOhm load): Super-cardioid: 122.7 dB SPL, Self-noise (equivalent sound pressure level): Super-cardioid: 26.5 dB, CMRR: At least 45.0 dB, Power supply: 11 to 52 V, Power consumption: 2 mA, Temperature range: -18 To + 57 ° C, Relative humidity: 0 to 95%

Les mer
Nux B-8 Wireless-System Git/Bass
Nux B-8 Wireless-System Git/Bass

Nux B-8 Wireless-System Git/Bass, Wireless System for Electric Guitar and Electric Bass, Compact transmitter + pedal receiver, WiFi 2.4 GHz, Built-in tuner or boost functions activated via the receiver footswitch, Built-in effects loop on the pedalboard receiver for buffered pedal signal paths, Balanced XLR D.I. output on the receiver for direct connection to a mixing desk/audio interface, Designed for electric guitars, electric basses, electro-acoustic guitars, electric ukuleles, etc., Optional cable tone function that provides the warm sound of a jack cable, Automatic pairing of transmitter and receiver in just a few seconds, Transmitter can be charged by placing it on the receiver screen (or via USB-C), Tuning modes: chromatic, standard guitar, guitar with compensation and bass, Tuning range: F#0 to C8- Tuning accuracy: ±1 hundredth of a semitone, 2.4 GHz high-definition 24 bit / 48 kHz digital audio transmission, Frequency response: 20 - 20 Hz, Booster: 0 dB - 12 dB, Output level adjustment range: Mute, -64 to 0 dB, Dynamic range: 122 dB, Latency : 2.5 ms (in low-latency mode for short ranges) to 8.7 ms (in stable mode for short ranges), Indoor range : 30 to 60 m (depending on environment), Outdoor range : 20 to 50 m (depending on environment), Transmitter battery : Li-Po 3.7 V / 500 mAh, Battery life: approx. 6.5 hours, Receiver power supply : 7 to 12 V / 500 mA mini (9V adapter supplied), Audio cable: 6.35 mm jack to 3.5 mm mini jack (sealed) supplied, USB-C cable supplied (charging the transmitter / updating the firmware), Weight transmitter: 63 g, Receiver dimensions (W x D x H): 72.5 x 49.3 x 23 mm, Weight of the receiver: 500 g, Receiver dimensions (W x D x H): 122 x 95 x 60 mm

Les mer
Sonarworks SoundID Reference for Speakers & Headphones with Mic
Sonarworks SoundID Reference for Speakers & Headphones with Mic

Sonarworks SoundID Ref Spk & HP w Mic, Reference for speakers and headphones with measurement microphone (box), Speaker and headphone calibration software and measurement microphone in a bundle, Precise adjustment of the frequency response to get flat and neutral sounding monitor speakers or headphones, Enables a more precise evaluation of recordings and mixes, Room analysis and automated calculation of the room size based on several measurements, Audio calibration engine allows for accurate processing, Save an unlimited number of calibration profiles for monitor speakers, Comes with headphone calibration profiles for more than 280 supported models, Target curve custom adjustments in real time, Translation check simulates over 20 different devices and device types for accurate mix translation results, 3 filter modes to choose from: Zero Latency, Mixed and Linear Phase allow to optimize filter quality and latency according to the monitoring situation, Additional processing controls for Mono, Dry/Wet and Safe Headroom, App only: MIDI mapping for various controls and user presets for predefined output device/channel pair combinations, Measurement microphone with a pre-polarized electret-condenser capsule, Frequency response: 20 - 20.000 Hz with calibration curve, Omnidirectional polar pattern, Sensitivity: 14 mV/Pa, Self noise: 24 dB, Signal to noise ratio: 70 dB, Dynamic range: 106dB, Maximum sound pressure level: 132 dB SPL, Requires 48 V phantom power, Connector: 3 pin XLR, Microphone calibration file for 30° off-axis measurements in Sonarworks software native format to be used with SoundID Reference, Microphone calibration file for 0° on-axis measurements in .txt format

Les mer